Magic88
Well-Known Member
- Joined
- Nov 30, 2023
- Threads
- 5
- Messages
- 693
- Reaction score
- 841
- Location
- Bennington
- Vehicle(s)
- 2024 Mustang GT
YESI always crank it up for Led Zeppelin and Steppenwolf.
Sponsored
YESI always crank it up for Led Zeppelin and Steppenwolf.
Try walmart.comSub is out of stock on Scuma'zon
Going to a local audio shop to get a "total" refresh on the shit Ford audio system that I had to pay for
Amp, Sub, speakers, and a new "REAL alarm system" along with front and rear 24/7 dash camera system ... to record little scum bags trolling the car in public...![]()
Nice! this was the first mod I did to my ’17 Raptor. How much amp did you put in?I wrapped my box in carpet & wired it to an AMP. Difference is night & day. Going to do a 4 channel & bypass my B&O System soon![]()
![]()
![]()
![]()
Just did a mono 1600W Pioneer Amp. Going to add a Taramps 400W Amp nextNice! this was the first mod I did to my ’17 Raptor. How much amp did you put in?
Where did you grab your input signal for the LOC fromJust did a mono 1600W Pioneer Amp. Going to add a Taramps 400W Amp next
Signal from rear sub wiring (only need one set from the dual voice coil) into the active LOC with bass roll off correctionWhere did you grab your input signal for the LOC from
Did you use the rear speakers, or take it from the factory sub output
They’re the same. Bass hits pretty good. Regardless, once I do the B&O bypass, I’ll have signal directly from the ACM split into a front / rear / bass channel. This was just a temporary install to get better bass & correct the roll offYou sure the signal in each of the two original sub lines are mono'd and thus the same?
If not, drums and bass instruments are not always placed in the center, so you'll miss sometimes something.
If Jersey wasn't so damn far away; I'd come over and pay you do do mine!Signal from rear sub wiring (only need one set from the dual voice coil) into the active LOC with bass roll off correction
I got the OEM wiring diagram so I was able to then wire the OEM connector plug out of the amp output back into the sub (plug and play)
Thanks. Ill look into getting the back ones replaced with amp for then and the sub. Infeel like the sound is isolated still but it is overall. Better with the replacement subYeah, it kinda is, the stereo favors the front stage heavily
you’ll probably need to add an amp an LC2I IIRC