Sponsored

Rev Matching. Yes or no?

Alex381

Well-Known Member
Joined
Jun 27, 2025
Threads
0
Messages
202
Reaction score
243
Location
Ohio
Vehicle(s)
2024 Mustang GT/CS Convertible
In the shortest terms possible: engine braking is a drag
Engine braking is fine and a very efficient way to slow down or moderate speed. Especially when you’re going down a mountain road. If you have 10 minutes downhill its way better to just sit a gear lower than normal and use zero fuel or brakes to maintain speed than it would be to sit on the brakes a little bit for 10 minutes straight.
Sponsored

 

Zig

Well-Known Member
Joined
Jul 21, 2023
Threads
37
Messages
4,732
Reaction score
2,582
Location
Virginia
Vehicle(s)
‘24 F350 cclb drw fx4 6.7ho, ‘24 gt pp, ‘05 c6 f55, ‘01 fatboy, ‘03 sprtstr
Engine braking is fine and a very efficient way to slow down or moderate speed. Especially when you’re going down a mountain road. If you have 10 minutes downhill its way better to just sit a gear lower than normal and use zero fuel or brakes to maintain speed than it would be to sit on the brakes a little bit for 10 minutes straight.
When we say:

If you’re going into a lower gear at lower RPM than you should then you are just burning up the clutch instead of your brakes.
are we referring to the upper or lower end of the rpm range for the desired gear?
 

Alex381

Well-Known Member
Joined
Jun 27, 2025
Threads
0
Messages
202
Reaction score
243
Location
Ohio
Vehicle(s)
2024 Mustang GT/CS Convertible
When we say:



are we referring to the upper or lower end of the rpm range for the desired gear?
Depends on the road. Too high and you’ll slow down, too low and you’ll keep gaining speed.

but the entry into the gear still needs to have the RPMs properly synced up to avoid burning the clutch.
 

Zig

Well-Known Member
Joined
Jul 21, 2023
Threads
37
Messages
4,732
Reaction score
2,582
Location
Virginia
Vehicle(s)
‘24 F350 cclb drw fx4 6.7ho, ‘24 gt pp, ‘05 c6 f55, ‘01 fatboy, ‘03 sprtstr
Depends on the road. Too high and you’ll slow down, too low and you’ll keep gaining speed.

but the entry into the gear still needs to have the RPMs properly synced up to avoid burning the clutch.
If you’ve got a drift handle shouldn’t be a problem
 

LouG

Well-Known Member
Joined
Mar 11, 2025
Threads
36
Messages
2,796
Reaction score
3,308
Location
New Zealand
Vehicle(s)
2025 Mustang GT
When I started my apprenticeship one of the older apprentices gave me a lift to nightschool. There's a very steep twisty stretch of road on the way and he demonstrated how to do the whole stretch without using the brakes, just engine braking, even down to first and slipping the clutch so it didn't over rev.
I was mightily impressed.
Sponsored

 
 








Top