Sponsored

Riding the clutch

Scryden

Member
Joined
May 30, 2026
Threads
2
Messages
6
Reaction score
8
Location
Calgary
Vehicle(s)
2026 Mustang GT Premium Convertible
I feel like this might've been asked many times before, but I couldn't find it specifically using the search function. Sorry if this is a repeat question.

2026 Mustang GT.

I was wondering from a wear and tear standpoint, how bad is it to ride the clutch at its biting point?

For context: I went to Costco today to fuel up. Costco has the cheapest gas in town, so everyone wants to get their fill there. As a result, I was sitting in a slow moving line for about 20 minutes. Every time the car in front of me rolled forward, I let mine slowly roll as well by releasing the clutch up to the bite point. In this sort of slow moving traffic there is no way to release the clutch all the way because I would be going way too fast. So is this bite point riding (not sure how else to call it) detrimental for the clutch or other parts? I feel like slow moving traffic is a very common occurrence where traffic ahead of you is simply moving too slow to release the clutch all the way.
Sponsored

 

Yamazuki

Well-Known Member
Joined
May 14, 2025
Threads
4
Messages
438
Reaction score
663
Location
North Dakota, USA
Vehicle(s)
2024 Dark Horse, 2013 Ford Raptor, 2004 F150
I spent roughly an hour and a half doing the same thing a couple weekends ago in a parade. As long as you're not overheating the clutch (you'll usually know if you do because of fade in the pedal and the bad smell that goes along with it), it's probably not really any worse for it than normal stop and go driving. If anything, I'd say it's harder on the throwout bearing since that is being worked every time you press the clutch pedal, and remains in use until the pedal is fully released.
 
OP
OP

Scryden

Member
Joined
May 30, 2026
Threads
2
Messages
6
Reaction score
8
Location
Calgary
Vehicle(s)
2026 Mustang GT Premium Convertible
I spent roughly an hour and a half doing the same thing a couple weekends ago in a parade. As long as you're not overheating the clutch (you'll usually know if you do because of fade in the pedal and the bad smell that goes along with it), it's probably not really any worse for it than normal stop and go driving. If anything, I'd say it's harder on the throwout bearing since that is being worked every time you press the clutch pedal, and remains in use until the pedal is fully released.
Ah, fair. Well as long as it isn't too terribly bad for it. I would just let it idle roll forward but its a stop and go unfortunately. This would only happen during traffic congestion and Costco gas fill ups. I could go to a quieter gas station, but a tank of premium 91 gas for $10 cheaper than elsewhere is hard to turn down.

The car is still in its initial 1000 miles break in period by the way, if that makes any difference.
 

dusman59

Well-Known Member
Joined
Mar 8, 2023
Threads
11
Messages
869
Reaction score
879
Location
AZ
Vehicle(s)
2011 GT glass top & 2024 GT
Riding the clutch is when one uses the trottle at much higher RPM and doesn't fully engage the clutch. Some people will also feather the clutch while greatly varying RPMs and not moving the car little distance.
 

Yamazuki

Well-Known Member
Joined
May 14, 2025
Threads
4
Messages
438
Reaction score
663
Location
North Dakota, USA
Vehicle(s)
2024 Dark Horse, 2013 Ford Raptor, 2004 F150
The car is still in its initial 1000 miles break in period by the way, if that makes any difference.
Nope. You'll be just fine. 👍
 
OP
OP

Scryden

Member
Joined
May 30, 2026
Threads
2
Messages
6
Reaction score
8
Location
Calgary
Vehicle(s)
2026 Mustang GT Premium Convertible
Excellent. Thanks guys :)
Sponsored

 
 








Top