Keep speed warning and lane assist setting after next engine start

[Fruitstang]

I understand that @Quarktasche wants to keep the warning but add a tolerance to it so chimes don't go off at 1 kph above the limit.

Would love to have this working for the adaptive cruise control as well.

Best way for EU configuration for toggling warning chimes on/off is what I wrote in the initial post.

Sponsored

 

[rugedraw]

I understand that @Quarktasche wants to keep the warning but add a tolerance to it so chimes don't go off at 1 kph above the limit.

Would love to have this working for the adaptive cruise control as well.

Best way for EU configuration for toggling warning chimes on/off is what I wrote in the initial post.

AFAIK, the only tolerances you can configure is for intelligent adaptive cruise and predictive speed assist/curve control on vehicles that have it available.

 

[Quarktasche]

so I just made it toggleable, didnt bother with the trying to tune it. good work @Fruitstang

concerning the missing tolerances: as I'm aware tolerances are totally fine and many vendors offer more relaxed modes. even speed cameras have tolerances ffs. wild that out of all cars mustang drivers are forced to drive like grannies and hump the speed limit

 

[Zbychersky]

Here's one of THE most useful changes I've made so far.
In some countries it's mandatory to have above mentioned settings to switch back to "On" after each new start of the engine.

So with the following changes that annoyance is history!

IPMA
706-02-01: "xxxx" "xxxx" "x1--"
706-05-01: "x4x0" "xxxx" "xx--"

Edit: There was a third line which did not have to be changed.

Enjoy your new life with the Gen7 Mustang!

Thanks! Works like a charm!!!

Sponsored