Sponsored

Search results

  1. Can you turn the boost down below 7 lbs on a Hellion Twin Turbo kit?

    Meth setup/tune is more complicated (you have to pull fuel for the meth you add) Chance that something goes wrong with the meth system, pump failure, clogged jet, doesn't turn on... Your intake manifold was designed to flow air, not water mist/meth, you end up with unequal distribution Most...
  2. Can you turn the boost down below 7 lbs on a Hellion Twin Turbo kit?

    I'd like to see some numbers on EGT's and coolant temps and whatever else, doing pulls on e85 vs 93. I posted before some study Ford did and as far as exhaust manifold temps went there wasn't much difference. For 20 minutes of load you're going to hit whatever danger zone there is, gas or e85...
  3. Can you turn the boost down below 7 lbs on a Hellion Twin Turbo kit?

    You aren't going to be on boost for 20 minutes. I would ask the Hellion Facebook group or email Hellion themselves. I'm sure someone has tried to run a minimum boost setup. E85 helps against detonation but the 'cooler burning' isn't going to stop you from cracking a ring/piston, people do it...
  4. Cat-Back Exhaust Help Please - Recommendations?

    If your wife doesn't like loud exhausts, stay away from the Borla ATAK and the Corsa Extreme. They both sound terrible anyway.
  5. Can you turn the boost down below 7 lbs on a Hellion Twin Turbo kit?

    You could run no spring and control pressure with CO2 if you really wanted to However, the wastegate only bleeds off so much boost so there's a minimum it will make no matter what. Why turn it down so low?
  6. ( HELP ) Whipple Problem going WOT giving me a Wrench light .

    The speed limiter would throw a trans fault code? Sounds fishy to me
  7. The Laptime Tie Is Broken — ZR1 vs GTD vs GT3 RS with Randy Pobst On Track

    The GTD has lost every track test that's been published. It's not like this is a fluke.
  8. Help with springs/dampeners

    Thought about swaybars? Edit: read this before you waste more money on strut tower and K member braces... https://www.s197forum.com/threads/bmr-k-member-brace.141927/#post-2548582
  9. The Laptime Tie Is Broken — ZR1 vs GTD vs GT3 RS with Randy Pobst On Track

    The track in the video has been recently replaced but race tracks aren't as smooth as you might think My point was even thought the ZR1 only beat the GTD by a few seconds (with a GM engineer as the driver), when you put it on the same track with the GTD with the same drivers, the GTD is losing...
  10. Oil change - Advice needed

    Letting it drain is good Maybe they added Liquid Moly Ceratec additive? That's a perfectly fine amount of oil to have You typically follow the dipstick reading for oil level. No. You sound like someone who would benefit from changing their own oil so they know it's "done right."
  11. The Laptime Tie Is Broken — ZR1 vs GTD vs GT3 RS with Randy Pobst On Track

    Younger guy drove them all on the SavageGeese video
  12. The Laptime Tie Is Broken — ZR1 vs GTD vs GT3 RS with Randy Pobst On Track

    This shows Nurburgring times don't meat diddly. Also, rmemeber when everyone said Ford was going to go back and beat the ZR1 time?
  13. Need help tires and wheels

    Yes Staggered would be bigger in the rear than the front
  14. Top Gear - Corvette ZR1 vs Ford Mustang GTD: Against The Clock on Track!

    We're talking about the specific suspension on this specific car. It wasn't a new design to use tires or an engine in this car either. You are dense... This one from the AM one is totally different...
  15. Top Gear - Corvette ZR1 vs Ford Mustang GTD: Against The Clock on Track!

    You know DSSV is just the shock, right? Plenty of other vehicles have them (like Camaros and trucks) and they have nothing to do with the GTD rear suspension You're telling me they just pulled this whole thing off the shelf?
  16. Top Gear - Corvette ZR1 vs Ford Mustang GTD: Against The Clock on Track!

    That suspension is not an off the shelf part....
  17. Top Gear - Corvette ZR1 vs Ford Mustang GTD: Against The Clock on Track!

    GTD is literally built on a bespoke front and rear suspension, custom transaxle, by a race shop.... Corvette rolls of a production line
  18. Top Gear - Corvette ZR1 vs Ford Mustang GTD: Against The Clock on Track!

    How good is it? It can't even beat a non-race car that's half the price.
  19. Does H/X Pipe Void Whipple Warranty?

    You're good. No headers allowed but catbacks are okay.





Top