Paddle shifters not working after install and ForScan changes

[wtfcr0w]

Hello everyone,

I have a base model 2024 Mustang Ecoboost and wanted to install paddle shifters. I ordered one of the GT wheels from Ford Performance and installed it. I changed the values that have been around here on the forums as shown below:

- Install new steering wheel
- Enable Select Shift in FORScan
(PCM 7E0-163-01 xxxx xxxx x*--) change 1 to 2. "L" gear shifter will be like "M"
- Enable Gear Select SST in FORScan
(IPC 720-02-01 *xxx xxxx xx--) change 0 to 4. this will show “M" in cluster to actually show gears.
- Continuous Gear Display in FORScan
(IPC 720-12-01 xx*x xxxx xx--) change C to E.

All of the changes seem to have worked, however, when trying to shift with the paddles the car doesn't shift. I did get a strange warning when changing the value for Gear Select, something along the lines of the value might be wrong, and when I went to change the Continuous Gear Display, it was already set to E.

The wheel came with the additional buttons for adaptive cruise and whatnot on the left, so I thought that might be the issue. I took the buttons from my stock wheel and swapped them, but it's still not working.

Is there anything I can do or check to troubleshoot this? I'm new to ForScan so it's possible I did something incorrectly. I did take a backup, though, thankfully.

Any help would be greatly appreciated.

Sponsored

 

[D/\rK•650]

There is another member that successfully did this. Here try this post. Goodluck https://www.mustang7g.com/forums/th...ddle-shifter-setup.174158/page-2#post-3479199

 

[wtfcr0w]

There is another member that successfully did this. Here try this post. Goodluck https://www.mustang7g.com/forums/th...ddle-shifter-setup.174158/page-2#post-3479199

OH! My apologies. I was looking at the second page. He says in the first page that he made the forscan changes before installing the wheel, then it worked correctly when installing it. Nice! Thank you so much!

 

[D/\rK•650]

Your most welcome! All the best

 

[Will2]

I installed a Dark Horse wheel on my base Ecoboost last weekend and it worked.

- I had previously done the IPC 720-02-01 change (to show "M" and gear number).
- My IPC 720-12-01 was already "E" (Ford updated the default setting I believe)
- After installing the wheel, I made the PCM 7E0-163-01 change (to hold a gear when shifted to).

Everything worked after that.

 

[wtfcr0w]

I installed a Dark Horse wheel on my base Ecoboost last weekend and it worked.

- I had previously done the IPC 720-02-01 change (to show "M" and gear number).
- My IPC 720-12-01 was already "E" (Ford updated the default setting I believe)
- After installing the wheel, I made the PCM 7E0-163-01 change (to hold a gear when shifted to).

Everything worked after that.

Ah ok. I'll give this a shot. Thank you!

Sponsored