CoolMonkey
Well-Known Member
Here is the video
Sponsored
Post or send me your VIN. I'll poke around and see if I see anything that stands out.Here is the video
Post or send me your VIN. I'll poke around and see if I see anything that stands out.
Your car is reporting some codes that coincide with possible connectivity issues. The ethernet failure and lost comms codes between the GWM and TCU modules are not normal. This could be due to a possible bad connection between the modules or a faulty module. Your dealer is going to have to look into this to figure out the cause. I was able to pull the connected data when I checked your car, so it seems the issue is intermittent. Tell your dealer that your modem works whenever it wants to. When the pull the codes, they will see this.I messaged you with it. I appreciate it so much.
Your car is reporting some codes that coincide with possible connectivity issues. The ethernet failure and lost comms codes between the GWM and TCU modules are not normal. This could be due to a possible bad connection between the modules or a faulty module. Your dealer is going to have to look into this to figure out the cause. I was able to pull the connected data when I checked your car, so it seems the issue is intermittent. Tell your dealer that your modem works whenever it wants to. When the pull the codes, they will see this.
![]()
To answer your original question: You OTA dashboard is below. No updates have sent to this vehicle yet.
![]()
It first reported it on 6/15. I am not sure how invasive a dashcam install can be, but I doubt that is what caused this.Thank you. Can you please check if it happened before the 20th? I had an oil change and they installed a dashcam for the car.
If you have FORScan, reboot the GWM and TCU.Have been seeing this for three days. It's on the internet when in the garage. I did get one update a month ago. Has this happened to anybody else ? Re-boot something maybe ...
Thanks
No FORscan for me (yet)If you have FORScan, reboot the GWM and TCU.
If you do not, disconnect the negative battery cable for 20 minutes and that should ne enough to cause both of those modules to reboot.
I use the Cobra White Gauges and the Default Gauges.I'm curious...which one do you like?
I use Fox Body...and if I had to use another one it would be the normal one. I don't get my information as quickly on the other ones with the bar graphs.