2025 GT: Two Months and 4k Wonderful Miles

[Cucurú]

Very nice car. Which spare tire did you get...made by whom? I need to get one. THX...FD

I seen a lot on Ford parts, and it was $390, I believe. Not sure if it will fit Brembos, if you have them. But it's about $100 cheaper than aftermarket. Also is a complete kit. Im going to have to order a couple. Unless I order aftermarket wheels. I may be able to use my stock 18s as spares, if they fit into the wheel wells.

Sponsored

 

[AZ_Ryan]

The below Pioneer on Amazon. Install was easy. Yes, plug and play with pigtails and just a slight adjustment. I also added the Polyfill. I have included the link to instructions that made it easy and straightforward.

https://a.co/d/gPj7Jpg

https://www.mustang6g.com/forums/threads/b-o-10-sub-replacement-guide.148813/

Thanks. I did find this video after posting. He's used the exact same part. Looks like the only downside is breaking the clips on the ring, and getting the new speakers holes to line up.

 

[DT-GT]

I used that one. Yep, good guidance.

Thanks. I did find this video after posting. He's used the exact same part. Looks like the only downside is breaking the clips on the ring, and getting the new speakers holes to line up.

 

[AZ_Ryan]

I used that one. Yep, good guidance.

Any advice about the clips and holes? Or did he do a good job in the video?

 

[DT-GT]

No advice. He shows it well in the video. Take it slow and cautious and it goes well. It is a big improvement over the cheap OEM sub.

Any advice about the clips and holes? Or did he do a good job in the video?

 

[Cucurú]

Seal it tight. Use that grey foam with one side of sticky stuff, and apply it to the rear of the speaker. It'll be air tight.

 

[AZ_Ryan]

No advice. He shows it well in the video. Take it slow and cautious and it goes well. It is a big improvement over the cheap OEM sub.

Just ordered everything online. It arrives Saturday.

Sponsored