Search results

Same here, but through ebay. Hard to find an 8ohm 3 1/2in speaker. Hope it's an easy install like the 4ohm Infinity.

So even though the B&O system is advertised as a 4 ohm system, not all speakers are 4 ohm. As has been said the front center speaker is 8 ohms and it looks like rear deck speakers may be 2 ohms each and are wired in series. Most 3 1/2 in speakers apesr to be 4 ohm. Currently researching Dayton...

Just called FRPP and they have no knowledge of a Performance Calibration Kit yet. So the good news is that Ford has the intent to offer one and they have an approved EO. Now it looks like they have to actually come up with tune and kit HW. EO did call out upgraded tune for premium fuel. DH...

Its called fat fingers, not sure how the kids do it :angel:

In above post, I could not see what vehicles EO applies too. Below show entire document which calls out 21-23 F150 and 2024 Mustangs GT & DH. Says tire size and gear changes only for user, and Ford will change tune for premium fuel use, but implies not letting user any adjustments to tune...

Just got mine, R2921 (~Jan 24), and I,'m the second owner.

Just got mine, R2921 (~Jan 24), and I,'m the second owner. And value of this kit IMO is for resale.

Mach 1 and DH have Tremecs so shifter sits on trans. GTs have MT-82. It's been a while, i used MGW, but Barton offers one as well, could be others now. So with my 13 GT, things weren't too bad till I had it tuned and increased redline. Then I added supercharger and would lose 3rd gear gate...

Positves- replaces top and bottom shift assemblies. Con- rear still mounts to body while front attaches to trans. Relative motion between both can cause shifting problems. On my 2013, I tried several fixes and ended up with not only replacing upper and lower shift mechanism, but one that...

The factory grill uses the same holes as the speaker. I also believe it will not work with Pioneer hole pattern. I use orginal holes as well and the stock trim ring. See pic below. And I tried to show the front of the grill were the stock trim ring attaches to the plastic pins. I fid an...

0.26 in and currently within 1 mph, not going to try FORSCAN to fix. But then i'm not sure how accurate it was to start with. Just happy to find 305s that fit my 10in rims and simliar diameter.

These are ones several of us have used. Made by Harman.

No dash removal. Grill pops off (metal clips) and speaker has 2 screws. New speaker bolts right in. I cut wires off of old speaker and soldered to new speaker. And since their sold in pairs, you can sell second one.

You will probably break the fastening tabs on the grill when removing the trim ring. The grill actually holds the trim ring in. So I used the stock trim ring to hide the speaker screws with a couple pieces of double sided tape. The 4 bar used 4 new screws and hold the trim ring in as well...

I went the other way and slotted the holes in the speaker, used the stock trim ring and 4 bar grill. This way i could go back to stock easily. Either way works.

Not if you go with 35 ratio. Diameter close to stock rear tires on DH. 305/35-19 27.40in, 275/40-19 27.66 in (stock rear DH non HP). I lnow car has more features then i have used, but where can speedo be calibrated thru dash ???

I remember a vent either. You can get poly fil at your local hobby store for about $5.

Amazon still has 10" Pioneer subwoofs for sale. Multiple sellers.

Definetly worth the money.

My R2921 gift is suppose to ship this week.