Good minimal drop lowering springs?

[5LTR550]

Yes they are the BMR perf min drop on my car.my bad on the last post.

been on a week . Dirty car but ill get some good pictures

this weekend.

Sponsored

 

[Silverstone]

Quite low for "minimum" drop springs. On our S650's the BMR Minimum Drop Springs look pretty much exactly as low as the regular BMR SP080 Lowering springs on the S550's.

I really wish the car was just 3/8 - 1/2" lower from the factory and I wouldn't have to bother. No one in the aftermarket is going to make lowering springs with that little of a drop from factory height. Even the J&M minimum drop springs I posted previously in this thread are lower than I would like on our S650's whereas on the S550's they look perfect to me.

Companies not bothering to update their springs for the S650's is really a shame.

 

[MattScopes]

Yes they are the BMR perf min drop on my car.my bad on the last post.

been on a week . Dirty car but ill get some good pictures

this weekend.

Your car looks damn good with the bronze wheels on the dark blue. Do you have any measurements from the floor to the top of the fender cutout so we can get an idea of how much they actually drop the car? Or any other insights, like how the gap between tire and fender compares front to back? Wondering if its worth putting a small spacer on the rear springs to raise the rear slightly to match the front air gap.

 

[5LTR550]

Your car looks damn good with the bronze wheels on the dark blue. Do you have any measurements from the floor to the top of the fender cutout so we can get an idea of how much they actually drop the car? Or any other insights, like how the gap between tire and fender compares front to back? Wondering if its worth putting a small spacer on the rear springs to raise the rear slightly to match the front air gap.

I like the ride rides a bit smoother than the 550. I have not measured tbh. Does have a raked look though. I Also haven't scrapped any speed bumps in parking lots so thats a nice thing as Well.

 

[5LTR550]

Different angle

 

[eriklieders]

I don't mean to be rude, but you're posting photos of some buses. Lowering should be low, without compromise. Otherwise, what's the point? My Mustang was originally lowered even lower. It was about 5 cm from the floor in the front, and about 9 cm in the rear.

 

[Jeffola]

I don't mean to be rude, but you're posting photos of some buses. Lowering should be low, without compromise. Otherwise, what's the point? My Mustang was originally lowered even lower. It was about 5 cm from the floor in the front, and about 9 cm in the rear.

Buses? I’m reading this entire thread because I want to reduce body roll and stiffen the ride a bit. I do not wish to lower the car at all, but if that is what gets the job done…. I’m seriously considering the BMR min drop.

 

[tj@steeda]

Here is what our Minimum Drop Springs look like:

Steeda Mustang Minimum Drop Lowering Springs - Linear (2015-2026)

https://www.steeda.com/steeda-555-8223-s550-minimum-drop-lowering-springs

555-8223

Front Drop: 0.75” / Rear Drop: 0.375”

Sponsored