Red Rocket’s Full S650 Mustang Stereo Project (9 Speakers)

[RedRocket]

For those wondering, the path to wire the center is easiest from the glovebox.

Also note, that JBL cant handle a summed load and will shut down at higher volumes. So you will want a better/different amp if you intend to run the center.

Sponsored

 

[Bassey O]

For the tune, you need a laptop.

you will want an ODB2 cable and forscan with a trial license to disable active noise cancellation (727-1-1, set the last three to 0EE3)

Use the USB cable to JBLs software to program the EQ. Be sure to set the input mixer to 2 channels only. The rear rcas are for the sub.
here are my settings.

Audio Post of the Year!!! (APOY) This is incredible. Great work sir.

 

[RedRocket]

Audio Post of the Year!!! (APOY) This is incredible. Great work sir.

You are very welcome.

 

[Jmatech]

Excellent write up.

I am doing a full system in a '24 with the B&O OEM setup and will post a similar write up here when complete. That is likely to be a few more weeks, perhaps a month as I am going a bit deeper, but I am glad to see others doing the same.

Anything I 3D print, I will share the files with those interested, but they will be very specific to the drivers I use - and I work for a transducer manufacturer, so not a lot of wiggle room on that.

The factory speakers are some of the cheapest things I have run across, the center channel driver in particular.

Agreed the B&O system is absolute trash. I’ve started re-doing mine in my 24 DH. Do you by chance have a 3d file for the center channel? I purchased an infinity 3032 cfx to put there for now until I can get a mobridge and a decent 6 channel amp.

Sponsored