Search results

ill give you $1250

is this listing still active?

min drop springs, camber plates + toe knuckle bearing. came out pretty well i think thanks tj/steeda for your help

just trimmed the bumpstops on my 24DH fyi you do not need to disassemble or remove the shock. just use a pry tool to pull down the boot. see pic

do bumpstops need to be trimmed here? 24 dh. conflicting info on prior posts

i figured out my mistake here. as usual, poor prep and sloppiness are to blame. having remembered this job to be easy the last time, i skipped some steps. this time i put the bearing in the freezer, heated the knuckle with a heat gun, put gear oil on bearing surface and unbolted the knuckle...

just tried to press m 5a460 bearing into the knuckle on my 2024 dh and the knuckle cracked. i did this on my 2015 s550 without a problem. any insights into why this happened?

apparently if the gap difference measured between the two springs is > 1/4 in then it is out of spec im getting one replaced

also, i suggest using bosch esi6 brake fluid. it is a low viscosity fluid that outperforms motorcraft/pentosin dot4 lv. esi6 dry/wet boiling point 520/360 motorcraft dry/wet bp 509/338 it is $18 on amazon for a quart

is there any point to clocking the bushings if lowering the car <1 inch?

not to plug third party software, but the iphone app store has an app called forscan lite. it is 8 dollars. with that and the obd mx adapter, it is quite easy to put it into service mode

i just purchase the magneride minimum drops. upon inspecting the rear springs, i noticed the top of the springs are asymmetrical left to right. the top coil is more widely spaced on one side compared to the other. the bottoms are symmetrical. does anyone know if this is intentional?

there must be a misunderstanding here. when i say bleed the brakes i mean push it out through the caliper. what you are referring to is flushing air bubbles out of the abs module i think

thank you that is what i wanted to know same procedure as s550 + brake service mode

has anyone bled the brakes in an s650 yet? if so please tell us the procedure

ford performance makes a version of the pp2 wheels Part Number: M-1007K-DC19XMB can anyone confirm they would fit a dark horse?

not sure how they pulled this off, but dark horse has shortest 60-0 brake distance of any pruduction car tested by motor trend...