Driver side front end rattle/flap noise at highway speeds

[Aggie1999]

This makes me nervous to have my oil changed at a Kwik Kar oil change place. Anybody have any issues with get their cars changed there?

Sponsored

 

[Ford Motor Company]

Not sure if this is what others are hearing but this is the crackle noise I am getting. Car only has 500 miles

Good morning. Feel free to send us a private message with your VIN and dealer info so we can look into this noise concern further. Thank you!

 

[kyeom]

I went to the official service center today.
There are quite a lot of stones embedded in the bottom of the skirt.
Let's just take steps to remove the stones and watch again.
I'll write again after about a week of driving to see if it's been taken care of.
Thank you.

 

[ccoulter]

Not sure if this is what others are hearing but this is the crackle noise I am getting. Car only has 500 miles

This sounds like what I’m hearing. Any fix?

 

[Idle0024]

This sounds like what I’m hearing. Any fix?

I did a deep clean and removed dirt from the side panels and haven’t heard anything after. I have the RTR side/back skirts and the back ones accumulate lots of dirt. Honestly unsure if that was it but I haven’t heard it again.

 

[MustangMental]

I did a deep clean and removed dirt from the side panels and haven’t heard anything after. I have the RTR side/back skirts and the back ones accumulate lots of dirt. Honestly unsure if that was it but I haven’t heard it again.

I just got a 2024 mustang 2 months ago and have heard the same noise. Which side panels are you referring to?

 

[Idle0024]

I just got a 2024 mustang 2 months ago and have heard the same noise. Which side panels are you referring to?

The side skirts by RTR. Depending on the package you got, you may have side skirts.

 

[MustangMental]

The side skirts by RTR. Depending on the package you got, you may have side skirts.

Did you remove them and clean them or just go underneath?

 

[Idle0024]

Did you remove them and clean them or just go underneath?

Did you remove them and clean them or just go underneath?

I used a blower to clean and installed custom plates to prevent dirt from going in again.
https://diyvan.com/products/2024-ford-mustang-fender-liner-hole-cover-panels-kit

Sponsored