Form Lighting

[RobertWins]

I am thinking about swapping out my side markers, reflectors, tail lights and reverse light to the Form Lighting products with the smoked lens.

Can anyone offer up their experiences with these products, suggestions, install guidance, etc.?

I am a little nervous about pulling the rear bumper for the tail light swap.

Sponsored

 

[SALEEN032]

Ive done all their products except for the tail lights, which are sitting in my garage waiting to be installed. Everything went nice and easy and worked perfectly. Side markers were simple to install, and the rear reflector and 4th brake/reverse light were fairly simple as well.

 

[UAS Guy]

I have their smoked side marker lights and love them. I haven’t had a single issue at all. I had them installed when I had the car wrapped so I don’t have any info on the install.

 

[Idle0024]

Installed tail lights and rear reflectors about two weeks ago. So far no issues and install was pretty straight forward. Very happy with them.

 

[Johnny_Casino]

Great product! Easy to install and look so much better. I installed side markers front/rear, as well as the rear valance led reflectors.

 

[Johnny_Casino]

Install video. Super easy to follow.

 

[RobertWins]

Install video. Super easy to follow.

Thank you. I watched all of there install videos, but sometimes they make it look easier than it really is!

 

[RobertWins]

Installed tail lights and rear reflectors about two weeks ago. So far no issues and install was pretty straight forward. Very happy with them.

Thanks. I get a little worried about pulling the bumper to get to the rear tail lights. I kind of figure if I am going to do it, I might as well do the marker and reflectors at the same time.

 

[Paul's stable]

Install video. Super easy to follow.

This guy is really lucky. I did the front no problem. Then the back would not come out. I tried many trim tools but they would not pop out. Had to do it their way and take a part the liner and bumper on the side need to separate. Did mine passenger side popped back in perfect the drivers side would not fully close and I striped the little plastic nuts. long story shot off to the dealer they fixed it $400 bucks. However they look so good I also did the reflectors and reverse brake light unit.

Sponsored