Sponsored

Dealing with winter....

RLE55

Well-Known Member
Joined
Jan 7, 2024
Threads
3
Messages
992
Reaction score
1,018
Location
37.5726028 / -85.1551411
Vehicle(s)
2024 Mustang GT Vert, 2025 Ranger
I condition the rubber seal with WD-40 so that the door/glass does not stick to the door frame. Then just run your car with max heater for 10-15 minutes, and the snow will unfreeze and just slide down.
Won't you get oily residue on the windows from the WD-40? Also, I'd be concerned some of the WD-40 might find its way onto tinted windows, if you have them.
(WD-40's main ingredients, according to its U.S. Material Safety Data Sheet* information, are: · 51% Stoddard solvent (i.e., mineral spirits: primarily hexane, somewhat similar to kerosene))
Sponsored

 

Dxm

Well-Known Member
Joined
Dec 26, 2023
Threads
13
Messages
252
Reaction score
185
Location
San Antonio
Vehicle(s)
2024 Mustang GT
Won't you get oily residue on the windows from the WD-40? Also, I'd be concerned some of the WD-40 might find its way onto tinted windows, if you have them.
(WD-40's main ingredients, according to its U.S. Material Safety Data Sheet* information, are: · 51% Stoddard solvent (i.e., mineral spirits: primarily hexane, somewhat similar to kerosene))
I don't have tinted windows. Use special WD-40 with silicone, which is supposed to be good for rubber. I saw an ad for it this morning, coincidentally, specifically for this purpose. You don't need a ton of it, just a thin film. In other words, don't flood your car, just take a paper towel, and make sure the weatherstrip is lubricated enough. I remember 4 years back I had trouble opening my car door because of the unexpected drop in temps after rain something like 5 F. I needed to drive somewhere, so I sprayed that stuff into the crevasses, and was able to open the door without ripping the weatherstrip off.
 

glenng6

Well-Known Member
Joined
Jul 8, 2024
Threads
1
Messages
735
Reaction score
733
Location
Easton, PA
Vehicle(s)
2024 Mustang GT Premium Convertible, Shadow Black
I don't have tinted windows. Use special WD-40 with silicone, which is supposed to be good for rubber. I saw an ad for it this morning, coincidentally, specifically for this purpose. You don't need a ton of it, just a thin film. In other words, don't flood your car, just take a paper towel, and make sure the weatherstrip is lubricated enough. I remember 4 years back I had trouble opening my car door because of the unexpected drop in temps after rain something like 5 F. I needed to drive somewhere, so I sprayed that stuff into the crevasses, and was able to open the door without ripping the weatherstrip off.
Dxm,
Tell me if I am wrong but what I believe you are talking about is Specialist Silicone spray made by WD40, the brand name. I use the same spray anytime I want to lubricate almost anything. Glenn
Sponsored

 
  • Like
Reactions: Dxm
 








Top