Search results

@Ewags81 ..... I am well known at the Ford dealership I deal with. I don't gripe about prices, I want the best (full synthetic) etc. for my Mustangs and I tip (reasonably) BUT there is an understanding I "know" vehicles (cars, boats, sleds) and if you mistreat my vehicle I get to claim your...

@9secondko ..... the panel alignment of my 2024 Premium GT Convertible also has excellent panel alignment. I did have two minor paint drips at each end of the trunk which struck the deck below but I sanded then down with a nail file and touched up the four spots so I have no panel complaints -...

@Ewags81. There's still plenty of hope for a 100% full recovery. The front air snorkels just abut the front end and are loosely attached to the grille area of my 2024GT and therefore have some movement - they have to as they are attached to the engine and must be somewhat independent. . Some...

@steveo1960 ..... respectfully do not mess with this. It is so easy to crack the windshield or damage any of the sensors in the glass. Your dealer might not even touch it and just send you with a W/O to a specialty glass shop. Yes, you could try heating the glue and removing it and then...

@Ewags81 ...... correct me here - I don't see any paint damage. Is anything broken? Does this section just snap back on or are nuts/bolts involved. Not trying to minimize or ask a dumba$$ question but I have watched a ton of videos of the Mustang assembly lines and thought I have seen the robot...

@Illini4 ..... you are 100% right that Ford monitors this site - which is smart of them to get knowledgeable insight from the most educated Mustang owners in the 'verse. I'd also bet a load that there have been some discussions at Ford as to what the h3ll someone was thinking when they let those...

@Dxm ..... looks like one of the plugs you use to fasten floor mats. Where did you find it?

@steveo1960 ..... sorry to take a few days to reply. If you didn't drive far a shop vac with a with an extension wand will do. That worked for me. Then clean as much of the remaining grit off with a rag. A friend drove for a couple of months and had to put it on a hoist and remove the bottom...

@n_123 ...... I'm sure you have checked the lug nuts on the wheels. At 100 mph any degree of off-torque can quickly cause a vibration. As well, if you will be going over 100 mph I would have my wheels balance checked - by a professional shop (not the dealer). Afterwards they can be torqued...

@Grabber1 ..... awesome tip. I sanded down the one provided by my dealer (I don't advertise) and painted it flat black. Yours is waaaay better. Maybe Bezos will give you a cut?

Q6543.....that oughta scare the $hit out of any potential competitors. Google 2000 Coyote beats Lambos ..... similar rear tire set-up. :-)

Love Mustangs and have had so much fun with them over the years that I decided to get out front of the coming rush and place my order. This should allow me plenty of time to option it ahead of time. I have reached out to Ford for their list of options and Steeda, LMR, Whipple and other suppliers...

@89Trooper and @Neggytive ...... Not sure if an S550 strut brace will fit an S650 but you can certainly get (and I highly recommend you do) a strut brace for your 2024 from any Ford dealer for a decent price and the addition of that WILL tie in to the two braces that are already there from the...

I agree that 60s and 70s break-in procedures are no longer required. Neither should it be babied. IMO "lugging" it causes as much harm. I do vary the engine rpms and speeds at which I brake to a stop from for the first 800-1000 miles. I would not be bouncing off the rev limiter for at least 500...

@smurfslayer ..... great question. I have been told to completely disable it involves cancelling other telemetrics so you may not get some Ford up-dates. I think I inadvertently disabled my lane holding feature (which I liked) and that may have shut-off the "keep two hands on the wheel" and "I...

@Loucas @TimSez ......the keep two hands on the steering wheel also has a potentially SINISTER aspect. If we are in an accident that is not our fault will the car codes shared with insurance companies show we had been warned 50 times to "keep two hands on the wheel" and will that be held against...

@Ciulster ..... and I apologize too. I was too quick on the draw myself. I apologize and I'll get some more sleep myself :-) I understand the parts 100% and as a long time Ford owner (3 mustangs) I was pi$$ed after spending 70 grand and looking at those holes and the chipped paint on my pinch...

@Tomasfish ..... right on brother. You have hit it 100%. I installed these six months ago after a 400 mile drive from the dealer. I had to touch-up the damage before I installed the kit. I was pi$$ed! If someone doesn't want to spend 100 bucks and 30 minutes on a fix to prevent the magnitude of...

@Ciulster ..... not so fast on the draw. Geez buddy did you wake up on the wrong side of the bed. FYI Hein had to get the blueprints from Ford re-configure them to have his CAD accept them, run multiple attempts, determine the best composite and materials to attach them to the felt surfaces...

@1hotboss ..... you're welcome, happy to be of any help. Have fun choosing! As a comparison here's a pic of my (former) 2014 Mustang with an "all black" interior. Thought you could do a quick scroll up/down to compare. Still really nice, but IMO the grey kicks the look up a notch. I sold it to a...