Underbody Liner Retaining Clips (Part Number?)

[Benvolio]

My 2024 GT’s underbody liner is sagging and appears to be missing some retaining clips near the driver’s front wheel well. My local dealership is pretty incompetent, so I’m hoping someone on here could provide me with the part number for these clips.

Thank you!

Sponsored

 

[CMcA]

any thoughts on just leaving the underbody off?

 

[Koverboy1911]

https://lmr.com/item/LRS-17626AHDW/mustang-belly-pan-hardware-15-17

I ordered these and they're pretty good

 

[Benvolio]

any thoughts on just leaving the underbody off?

I’ve considered it, but I live in the North East and if I do drive the car during the winter, I’d like to avoid any corrosive containments from getting baked onto the bottom of the car.

 

[Will2]

Underbody Tray and Related Parts
--------------------------------
Screw and Spring Washer - 4.2 x 25mm (7mm head)
W715060S450B
15x (around periphery of splash shield)
(May rarely need to replace these)

Locking Pin - 8.5 x 10mm
"Two-Piece Push Pin"
W714975S300
3x (on front edge of splash shield)
(Stem is actually 8.5mm x 27mm)
Best non-OEM replacement: Auveco 20992 (https://www.rockauto.com/en/moreinfo.php?pk=12543397) (slightly short by 3mm)
Cheaper non-OEM replacement: https://www.amazon.com/dp/B07D6KRWLL (slightly short by 5mm)
These also seem to be easily available on eBay if you search the Ford part number for a part that is similar to what is on the Mustang: "W712196-S300"
(Turns out you don't even need these)

Radiator Support Splash Shield Clip Miscellaneous Hardware - Trim Pin 7.6 x 20
W709371S300
2x (in mid-section of splash shield)
Best non-OEM replacement: Auveco 23966 (https://www.amazon.com/dp/B0CK71FPHC)
Cheaper non-OEM replacement: https://www.amazon.com/dp/B09SD7KJXP
Judging by Ford's name for the OEM part "7.6 x 20", presuming millimeters, this would be 0.33mm larger in stem diameter and 0.64mm shorter in stem length, which seem negligible
These also seem to be easily available on eBay if you search "bumper push pin" and the specs should be 8mm x 20mm (stem width x length)
(Turns out you don't even need these)

Expansion Nut Bumper Splash Shield
W716529S900
(W715060S450B screws into this, shouldn't ever really need to replace these)

Engine Compartment Splash Shield
PR3B6B629AB aka PR3Z6775A
(Shouldn't ever really need to replace this)

Source: https://parts.ford.com/shop/en/us/b...gt-feature-car)-p-pr3z6775a#/collapseRelated5

Sponsored