Wolfman5
Member
- Joined
- Feb 28, 2017
- Threads
- 1
- Messages
- 7
- Reaction score
- 12
- Location
- East Central Florida
- Vehicle(s)
- 2026 GT Premium
- Thread starter
- #1
Hello! So I'm finally building the show car I always wanted and currently we are installing an Air Lift kit. Its a 2026 GT Premium, PP and Magneride (didn't want MagRide, but dealer made me a deal I couldn't pass on). I already have the resistors to bypass the MagRide shocks, but now I see there's ride height sensors front and rear.
We are worried that leaving them in their factory spot will either hit the bags (not sure yet), or the extra up and down height the bags will provide will be more movement than the sensors can handle.
So do I:
(1) Leave them where they are, send it and hope for the best,
(2) disconnect them from the control arm and leave the sensor connected but tuck it up and away, or
(3) is there a way to delete them without causing any issues?
Its a completely new platform to me, so I'm trying to learn and figure this all out as I go.
Thanks in advance!!
**** Not my picture, but these are what I'm talking about****
We are worried that leaving them in their factory spot will either hit the bags (not sure yet), or the extra up and down height the bags will provide will be more movement than the sensors can handle.
So do I:
(1) Leave them where they are, send it and hope for the best,
(2) disconnect them from the control arm and leave the sensor connected but tuck it up and away, or
(3) is there a way to delete them without causing any issues?
Its a completely new platform to me, so I'm trying to learn and figure this all out as I go.
Thanks in advance!!
**** Not my picture, but these are what I'm talking about****
Sponsored
