I got the decals and the coolant cover (not a decal) from Ancor Room. And I literally just ordered that same strut brace plate!I like those stickers, where did u get them? I had a personalized one on my strut tower brace.
You can run track mode anytime or as long as you want. The manual says it's not for street use (probably because it reduces TC and some other nannies), hence why it gives you a message everytime you turn it on.
Anchor Room's stuff is pretty good. I don't recommend the badge behind the Mustang inserts on the radiator cover. It started flaking off earlier this year, I'm assuming, from the water coming through the hood vent when I would wash it.
Good to know.Anchor Room's stuff is pretty good. I don't recommend the badge behind the Mustang inserts on the radiator cover. It started flaking off earlier this year, I'm assuming, from the water coming through the hood vent when I would wash it.
Yep, and then to have one painted made the spaces even smaller. I spent over an hour getting them on, massive pain in the ass. For the casual fan, they like it, for ocd like me, if it was on the outside able to be seen everyday, I probably would have taken them off by now, haha
It’s part of my MyCustom Mode and it’s on 100% of the time. And I see that same alert for “Track Mode Use Only”.
How did you apply that strut plate? I just got mine today, and I was under the impression you could put it right over the factory one. But it doesn't lay flush.Anchor Room's stuff is pretty good. I don't recommend the badge behind the Mustang inserts on the radiator cover. It started flaking off earlier this year, I'm assuming, from the water coming through the hood vent when I would wash it.
Is your strut brace factory? Mine is and had no plate on it, I don't think any performance pack 24's had plates, just the holes.How did you apply that strut plate? I just got mine today, and I was under the impression you could put it right over the factory one. But it doesn't lay flush.
How difficult was it to install the hood decals?An update:
New Wheels and hood decals.
Drill the pop rivets out and you're goldenI bought mine as a take off from a guy who supercharged his car. I know some cars didn't come with the plate, but many did.
It took some patience and some technique to get the bubbles out. In the end it turned out really nice. Keeping the decals lined up straight without getting creases was tricky because of the hood contour and slope. Definitely get the wet spray and felt applicator squeegee with the decals. Ancor Room sells everything you need but masking tape.
