JPGC_S650’s 2024 GT Build thread

[JPGC_S650]

UPR Catch can and STB installed.

Sponsored

 

[JPGC_S650]

Soon…these are the Steeda Minimum Drop linear springs. Just wanted a little extra stiffness with a little bit of drop.

 

[REV745DH24]

Look what arrived today!

Let me know how MGW shift does!

 

[JPGC_S650]

Let me know how MGW shift does!

Still got to install it. I plan to do the MGW and the springs at the same time.

 

[REV745DH24]

Testing out the Quick Jacks

How would you put the jack bars underneath the car with Quick Jack in the way? I’m curious?

 

[JPGC_S650]

How would you put the jack bars underneath the car with Quick Jack in the way? I’m curious?

I already added the jacking rails before the quick jack. I used a regular ole jack/ jack stands when I did that.

 

[JPGC_S650]

Quick cold start/ idle video with the Steeda H-Pipe and stock active exhaust in normal mode.

 

[IPB]

Sounds great, and love that RTR duckbill!

Can't wait to see it after the springs go on!

 

[JPGC_S650]

Oh this sucker is LOUD, lol, and deep. In normal, sport, and track modes at least. In quiet mode, it’s a lot more tame and removes the drone for the most part.
Flowmaster Outlaw system w/ active exhaust and a Steeda H-pipe.
I’ll get a video added soon. I still need to tweak the alignment slightly after some heat cycles.

 

[TXGT29]

Looks great. Looking forward to soundclips. How's the drone, as that is what I was reading from some other's input.

Thanks

 

[JPGC_S650]

Looks great. Looking forward to soundclips. How's the drone, as that is what I was reading from some other's input.

Thanks

There is drone, though not fox body with no cats and Flowmaster 40s or 10s drone. I like some drone so I should remain happy with this kit. Plus quiet mode takes most of the drone away.

 

[TXGT29]

There is drone, though not fox body with no cats and Flowmaster 40s or 10s drone. I like some drone so I should remain happy with this kit. Plus quiet mode takes most of the drone away.

Thanks for the note. I don't mind some drone either. And if changing mode with AVE for long trips resolves it, I'm good.

Looking forward to clips. This uses stock mounting locations, right? Seems like the tips stick out farther, but could just be the angle.

Thanks again.

 

[JPGC_S650]

Yep, the same mounting locations. The tips are larger than stock (4” vs 3.5”) and do stick out a little further….at least how I have it aligned. I could probably push them in a little further but being that the pipes under the car are 3”, there isn’t a whole lot of wiggle room without causing rubbing issues.

 

[JPGC_S650]

Updated with video:

 

[JPGC_S650]

Finally got the MGW Race shifter installed. Not a difficult job but quite the annoying install. On to the springs next….

Sponsored