Install Steeda jacking rails.
Raise car.
Put on sturdy jackstands.
Jacking stands will be far more useful than $265 (14" ramps for my DH) ramps when not in storage, too.
Nope. Changing colors doesn't transform it enough. Legally speaking, there is also no specific 'percentage' of change, per se, either.
See Cariou v. Prince, 714 F.3d 694 (2d Cir. 2013) as well as Kienitz v. Sconnie Nation, 766 F.3d 756 (7th Cir. 2014)
Further ...
Under 17 U.S.C. § 501, an...
It's all relative, especially when rates are/were down in the 1.xx% range. That's almost like using someone else's money for free. If you are/were able to invest the money (that you could have used to pay cash for the vehicle) into something that earns MORE interest than what you're paying on...
OK, @mijack1989 - How did you get the image to post at the TOP like this:
I've seen many posts WITH an image up there, and many without. Can't figure out for the life of me how to do it.
AFAIC, the primary purpose of the ESPs is to avoid having to pay a monster bill for a major repair (engine, trans, etc.), not necessarily the nickel and dime stuff.
Are you running a trickle charger or a battery maintainer? The older trickle chargers won't stop/start the charge process (it just shuts down when reached and won't restart unless you unplug/plug back in), but the latter does.
If you're pulling more than 0.5 to 0.7 amps @ rest, you've got...
The nice thing about the Ford ESP warranty is if you do not make a claim on it and you sell the vehicle, you can get a pro-rated refund. At least that's the way it worked when I sold my 2017 F350 Powerstroke in 2019.
That's said I do not typically buy the extended warranty, as I usually trade...
Have not check/tried this in the DH yet, but I used FORScan to adjust how long the powerpoint stays active in my F150. I believe I changed it to 20 seconds.
You should check the other thread on this forum. I communicated with the Ford aerodynamic engineer on the S650 as well as his boss (thru one of our engineers). They said it was perfectly fine to close these. They are there to facilitate the manufacturing process. No, there is no plan to close...