Search results

I will not be ordering, either, but mainly because I am too poor. There is more to this than what you have done to your car, however, especially in the area of removing heat from the oil and coolant.

Is this supposed to read "on" instead of "om?" I ask only because he was asking about tune on gasoline, E10. And apparently wherever his van down by the river is located, they can purchase a maximum of 92 octane (Washington?).

Does not look as wide on the wheel as I would have thought from what I can tell on those two photographs. Thank you for posting them.

If you could ever post a photo of how the tire fits on the wheel, like a somewhat close up of the wheel and tire from a side angle, front and rear, so I could see how the sidewall extends out from the wheel, it would be vary appreciated. (But I understand that is a pain in the ass request...

From what sort of baseline? The stock numbers seem to always be different, from 380 to 420, which is a huge range.

Interesting. Are these on the stock Ford wheels? Are the tires the 3 or the 3R? They have a 12.3" tread width (according to Tire Rack), so I had sort of ruled them out as a tire choice for an 11" wheel, since that is 1.3" wider than the wheel width. Even the 305 is listed at 11.6", still...

I am just impressed that a sales manager lives next door to a guy who can plunk down half a million for a car and runs in circles with folks who can plunk down over a million. Maybe I chose the wrong career.

6-7 mm should not make an appreciable difference in ride quality, feeling road imperfections.

MightyMars disappeared on us without an update from Palm Beach Dyno. Maybe the board of directors at Ford Motor Company had him killed because he knew too much?

Ok, ok, metric system in Czech Republic . . . 🤣

I have been looking all over for the thickness of the Dark Horse radiator. I just found this thread and the 2025 post above using Google. Can anybody confirm this 31mm thickness? I am asking because that is a lot thinner than I would have expected. Mishimoto and CSF both make 42mm thick...

A difference in what?

I bought my car used with 800 miles on it, so the gift pack was probably sent to the guy who bought it and traded it in.

While useful for comparison, this chart was never intended to be a total and complete listing of all differences between the three engines listed, the way you are using it in this thread.

Thanks for posting that. Could you take a photo and post it? Thanks in advance.

You can fit a lot wider wheels than that on your S650 base model GT.

I am going to get a set, but 11" wide all four so that I can rotate tires (same offset as rear on front with a spacer to make up the difference). And in bronze. Note that they have sales around Thanksgiving and one other time where they drop the cost a couple of hundred bucks. I do like the...

Maybe now install just one of the Steeda wheels at a time and go drive.

Discount Tire is great for balancing where I live.

Did you call the dealer?