I have not had an issue but this vehicle make a lot of pops, clicks and noises after shutdown. And even when just opening the door to retrieve something. I thought there were mice or rats in the engine compartment when I drove the car home and stop at a rest area.
Just saying. Lots of relays...
I have an appointment Monday morning, the part is in. Someone here said it's 1 - 1.5 hour job. If so, it's not a real involved procedure. Anyone know how to R & R of rear half shaft?
I did get it to the dealer service and they found a hole in the boot up by the outboard clamp. Looks like a manufactor defect. They order a half shaft. I will drive a little since the shaft will be replaced awyway. I hope shaft comes in soon and the dealer doesn't mess up anything else. Im at...
At 500 miles, I pulled off my left rear wheel and found grease all over the inside of the rim, on caliper, and suspenion. I also found a small hole in the outer boot. Called the local dealer and they had me bring it in right away. They confirmed a defective boot and ordered the complete half...
I only have 600 miles on my GT with the S/S system.
It has of yet shutdown at a light even though all the parameters are met. Maybe it needs to be broken in more???
I have 2 dealers with in 35 m8les of my abode. I will contact both and see which one will get me in the soonest. I dont need to drive the car as I have other vehicles.
Well, by how much was on the rim, caliper, and suspenion, I think it may be out of grease. Is the boot filled or just grease around the CV? They dont replace the just the boot? I guess maybe the half shaft comes as a sealed unit. I can see where the hole is and it look like manufacting...
My first post with an issue. I drove 550 miles last week and bought a silver GT. It rained half way home and the car got really dirty. I washed, clay barred, and polished her the next day. It's at 550 miles.
Today pulled each wheel off to clean everything. The left rear wheel was splattered...
I did the DIYvan thing today. They fit good and cover the opening well. Just try to keep the JBweld off your hands. It's tuff getting the stuff off.
I did the right side bare hand but learned my lesson and used gloves on the left one.