Search results

Tried this but it did nothing for me. I think something in the BCM also needs to be adjusted. Haven't found which one exactly.

if you only turn off the audio warning and the traffic sign symbol is visible they won't suspect. They do however check now if the symbol is there as it is a homologation requirement. Same like checking E-Call. They won't make a call but the indicator cannot be faulty.

Beim naechsten TUEV nicht vergessen wieder an zu machen ;)

@BimmerDriver can you share some Christmas Magic and show an image of your aux gauges menu with the TPMS? Thanks!

Apparently @BimmerDriver can see the tyre pressures in the aux menu on the main screen. Check his post on the previous page. I have activated the Temp Read out via ForScan already. I just cannot get to the screen in the Main Screen. I can only see the pressures in the IPC.

Hi, my Mustang is a US Spec. When I go via the Pony menu to the Aux Gauges I can only choose between the different layouts, 3 or 5 gauges, but not the tyre temps. Tried sliding the finger from the right but nothing pops up. Do you have the performance pack by any chance?

Just realising that this image is of the centre screen, not the IPC. Which menu shows the tire pressures in the centre screen? I could not find that.

All modern sensors can read pressures, temps and battery status of the sensor.

I just tried changing the setting in the IPC 720-11-01 Didnt work for me either :( @roket which line did you change in the BCM? Cannot find anything related to tire temp in the sheet.

It may need a change of the country code. Right now it is not showing anything. Just checked the sheet and might be change in the IPMA. But I don't want to mess with the country codes right now and potentially mess up the LDW/LKA and AEB. The HMI also does not show any option right now.

I would like to have this too. Although without the audible warning. Just the traffic sign. I can imagine this needs to be done in the APIM and IPC

Thanks for the feedback. Checked it with forscan and no faults present. The light themselves work if the switch is pushed to the left or when you press the lenses individually, just not when the door is open. Door ajar switches work as the dash shows a warning when the door is open.

Hi all, I had the airbag tell tale coming on now constantly. Before it used to come and go but the last week it was on everytime. The DTC read the rear passenger Pretensioner showed an open circuit. I folded the rear seats and took the trim of, made sure the all connectors are seated...

I can confirm this too. I have mine set between 24 and 26 Deg C. Even on the lowest Auto setting the fan blows quite hard so sometimes I have to manually set the fan speed to 2 or even 1. In the Porsche it would be set to 23, in the Audi 21-22 Deg C, which is quite normal for the human body...

Nobody? Is this really just a one off on my car? I took out the overhead console. Photo of the wiring attached. Didn't look damaged or anything. It would be great to know on which wire the signal should come when the door is open. I found a video that suggested to put a fuse on #1 on the...

Best I got down to is 6.05 seconds (no rollout). Bit of wheelspin in 1st and 2nd. 255s. I ve seen videos getting 4.5-4.6s. Track Mode, foot brake 2000 rpm.

This is still driving me nuts a bit. Quick question to everybody: Is your light switch illuminated? I noticed mine is not and I looked at few videos online and it seems to be illuminated. Not 100% from the videos.

Nope, but it might due to the fact that this car had aftermarket headlamps installed. Hence, I could not find LDCMA/B in the ForScan Modules. Confronted the dealer with it but nothing more I could do on that unfortunately.

Is there anybody in the forum who can reprogram the TCU?

Place a bet with him. If it works you don't pay for the work. If it doesn't work, buy him a beer.