Search results

how well would this hold up against water intrusion?

any plans on making a visor that extends a bit more behind the screen (the entire length of the sides) ?

yo i bet i could have my upholstery shop wrap this in leather with a blue seam. DM me asap ill take one and send it to get upholstered.

it was plug and play? i’m sure you needed to program the IPC to show the gears and accept the input. by default, he’ll have L gear when shifting down instead of M

check my profile i posted it. it’s from alibaba.

you’d need a rear steering wheel cover trim piece, new steering harness and a new SCCM. you’d then have to use forscan to program that SCCM and enable the respective features in the PCM and BCM.

how is the dark horse losing the indigo seatbelts 😭😭

alcantara headliner

$450 or best offer. takeoff from dark horse with 4.5k miles very light wear shipping not included local pick up in NJ

very easy install $640 on Alibaba included heated padding took over a month and a half to ship but totally worth it don’t buy from american companies as they are sourcing from Alibaba and adding a 100% mark up

i don’t get the need to reinvent the cold air intake from the factory. simply removing carbon traps and adding a high flow filter will get you to your desired gains. Also, those open lid systems are definitely going to trap heat

those are for your decklid if you didn’t already have a spoiler in your car and yes that’s the correct amount. i re used my old bolts

i’m getting a grinding sound when making left turns occasionally. Been super lazy to hit up ford for a diag

it’s harder to lay it flat and in one piece cause the trim panel hooks on to the gap where the regulator sits. the water shield isn’t exactly flat to do a cut out either. regardless, it does the job

you gotta redo your whole system to get the most out of it. I did a whole sound system overhaul. my ears ring every time i leave my car lol.

I put spacers on the rear. 25 MM i believe. They came with studs. had no problems at all

i just ordered an alcantara and smooth leather one. no airbag cover bc it’s stupid expensive and probably not worth it ever blowing up in my face. let’s see how it comes out. how did you wire the heater?

direct replacement! lots of tape removal so that was fun

spliced the center dash light, glove box light, and cupholder light using the ambient light below the glove box. Splice the door lights into the door, handle lights. The hardest part about the install was making the Lincoln cupholder fit. That took a lot of patience, trimming, and some hot glue.