Sponsored

Search results

  1. Good place to get factory 5.0 Air Filters?

    My recommendation is based solely on my own experience. Granted, I’ve never had to contact their customer service, but that’s because I’ve never had an issue with an order. If you want to pay Amazon an extra for less risk, that’s a personal decision.
  2. Good place to get factory 5.0 Air Filters?

    Been using them for over a decade, never came across an issue with anything fake
  3. Good place to get factory 5.0 Air Filters?

    It’s $14.61 each on rockauto. In my experience they sell Motorcraft parts for the lowest cost. Shipping is flat 10-ish, so i combine lots of other stuff like oil and oil filter.
  4. 2025 GT engine oil temp runs hot

    Since I watched that video on oil temp by Motor Oil Geek, my perception of oil temps have changed dramatically.
  5. Barely Drving Car in the Winter salt?

    I do the same. I don’t mind driving in cold temps, it’s the salt that I’m trying to avoid. I don’t have private parking either, so it’s on a public street With an outdoor cover. I vent it out once a week to get the moisture buildup out if the weather allows. At the same time I put it on a 15 amp...
  6. Display Burn-in

    My Bmw X5 i bought in 2022 with the LCD instrument cluster is yet to show any sings of ghosting or burn in. Based on my experiences so far, I doubt this is a concern.
  7. Driveshaft rust normal?

    Steering knuckle, tie rods, and some other odds and ends will look just like that if they haven’t already. Mine has patches of surface rust with no winter driving.
  8. Gross rotors (rust)!

    Yep. This is just from the spray of wet salt from other cars driving next to where I park.
  9. Gross rotors (rust)!

    All rotors in all vehicles except carbon ceramic ones in exotic cars do this.
  10. Steeda low profile jacking rails… yes or no?

    I didn’t buy any jacking rails (from Steeda or elsewhere) because i got torn between the low profile and the full length. One sits 1/8” lower than the pinch weld, which is something i want, another extends coverage to the actual jacking point, which is also something I want. However theres no...
  11. (DONE) Adding the Performance Package Trans cooler to a non-PP car

    Thank you for doing this. It’s good to know if I ever need to do this too, I’d have your post and experience to guide me.
  12. ZL1 Addons, Inc. S650 Deluxe Rock Guards install

    I really like these. What did you do for the rears? A mismatch between the fronts and backs don’t look weird?
  13. Headlight Condensation

    When LED headlights were just becoming a thing, I bought a car with one and posted about the condensation on a forum. Everyone told me the headlights were defective. Took it to dealer, they didn’t know why it was happening either and contacted the manufacturer, who then replied saying that could...
  14. Stock B&O sub to Kicker subwoofer 48CWRT104

    Factory amp, not other modification (just some sound deadening around the box). Amp is strong enough, it’s just the stock subwoofer that’s 💩’ty.
  15. B&O sound

    It’s loud but sound;s not clear. I had the a similar issue with my other car with a branded “high quality/cost” audio system. I replaced the speakers on that car with Focal’s, it wasn’t cheap but it was a night and day difference in audio quality. No amp or other mods, and it transformed the...
  16. Coolant level when cold

    Mine came at almost—low mark from the factory, then this is where it is after 2500 miles. I bought the Motorcraft pre diluted yellow coolant from amazon, will top it off when it comes out of its cocoon.
  17. Best air filter for the Mustang?

    I’m with the stock filter team, but i love those roush clear covers. I’m about to buy a set just for the covers.
  18. B&O subwoofer issue

    When I took the sub box out to replace the sub, i started the car without a sub connected, that was the first and only time I had that loud thump. (Obviously from all the speakers except the sub)
  19. UPR Catch Can Placement

    I just asked ChatGPT what the procedure is for Gen4 coyote pcv valve replacement. Said gen3 it was just a turnknob-like installation, gen4 has a platic piece that prevents that turn. Says some just break that black piece off and live with it, others who don’t wanna break it take the valve cover off.
  20. UPR Catch Can Placement

    I did, sent them a picture with the hose kinked more than what I consider to be reasonable. They said that’s pretty much what it is given the tight space. Some may accept it, some may never have an issue, but I just didn’t feel comfortable with it myself.





Top