Search results

They stated they looked into all of those things when I took it back in. Wasnt a problem before the install so leaving me kind of confused and I'm sure them.

They said the 4 cylinder mode is a safety feature for a misfiring engine, but then continued to tell me there isnt a fix. I will present these options to them and tell them they should check them during install before tuning the car to prevent some problems after-install. Thank you guys for input.

So been driving my 2024 GT Premium for over a year and a half, no issues. It had about 3700 miles and I installed a new racing clutch and short throw shifter last month in preparation for my supercharger install coming up later this month. After these two were put in, my car shakes in first gear...

I did some research and contacted whipple. Apparently if I remove the cats they will not tune it differently. I will still receive the basic tune with stock exhaust. My plan was to remove them before tuning, but with the tune set up to the basic exhaust system, will I face any issues not having...

So I am about to buy the whipple stage 2 and was trying to get some help from some experienced people. I have the GT Premium, manual. I am familiar with mustangs and have drove them my whole life, but supercharging is a whole new game to me. I am trying to not spend $23,000 on this supercharger...

Does anyone know why this could be happening where one side is dim and the other works fine? It could be anything due to the fact I just installed a splitter and once I put the bumper back on I have this issue.. Thanks in advice for any tips. @RTR Vehicles

I for one just wanted to share the beauty since I just put the grille on last weekend. Secondly, for anyone who was concerned when purchasing - it’s been a week now and my lights have not been affected. I will update if anything changes but it seams it really isn’t an every car problem (mines...

I recently took the bumper off to do an RTR grille swap and after watching a few videos, it seams one of the only ways to actually remove it require basically prying it off with a crowbar to remove it where it is attached to the fender. They say put painters tape down first (which i did) and low...