Search results

the oil temps the same. I use Mobil 1 full synthetic. and I didn't notice any hood flutter at least thru 120. goodlettjr just back it down a tad and your hood will be fine

no problems since the first oil change. just haven't reinstalled the underbody panel

I believe there is also a setting for the blue tooth connection to the Mustang in your phone settings which also needs to be turned off so that you don't get the 'unable to connect with your device... message on the dash display.

belly pan's been off for a year, temp and all gauge readings normal, car handles fine at least to 120 (as did my 2007 GT without a belly pan), satisfied with 21 avg mpg, can't think of what else it would be there for. otherwise its just a pain

looks like the tech floor jacked it one side at a time and then lowered it on jack stands. how did the pinch welds handle the jack? did you have him replace the belly pan or leave it off? any rattles, squeaks, tics afterward? looks like a good way to go

I've also been told by the dealer that's the DI injector (driven off the right side cam) and not to worry. Fine, but if you would not like to hear it is there a way to eliminate or quiet it down?

tell us what it was like to get the car up on the ramps. I purchased the same ones , took about 6 attempts to get the confidence to drive up on to them. only by the grace of God did not drive off . I've been driving stick since 1972, probably much easier with the 10 speed auto. I left the belly...

tho the cylinder head temp does seem to run 5-10 degree cooler

thank you eriklieders. straightforward

can you describe how to remove the monitor so that I can access the clips to tape and lube them. Thanks for the info. I have the rattle when sun is hitting the dash and the a/c is on.

any thoughts on just leaving the underbody off?

Anyone decide to just leave the tray/panel off after the first oil change?

was running Shell 93 in my 2007 GT and now in 2024 GT. Sunoco began offering 94 locally . ran my first tank and the avg MPG which has been a consistent 21.3 since new jumped to 21.5. and it still howls

ditto on the reference numbers on the aux gauges.

can't find a brush small enough. take a Qtip cut the paper stick on a sharp angle point with a razor knife. dip the Qtip point into the bottle and dab the stone chip. 1-2 applications allow some depth to remain for the clear also applied with the angle cut Qtip. On bare steel chips use primer...

I'm planning to do my own change though I haven't compared the cost of oil and filter to the dealer change. -Can anyone recommend a set of ramps to fit the 9" wides on my 2024 GT? Are the $60 plastic ones at Advanced Auto o.k.? -Has anyone left the underbelly pan off after their oil change? My...

already learned that from my 2007 GT. have been super careful since

although I have the digital values on my dash display, numbers on the gauge display would be an improvement, one of very complaints. My 5.0 in Normal running is around 14 and 20 when coasting in gear. does the above link to the air/fuel article imply the ratio changes in Sport or Track modes?

have used Motorcraft blend and filters in my 2007 GT and plan to use them in my 2024.

Congratulations , at last! Ditto regarding pictures and please keep the information flowing