When training/learning, Ford recommends keeping 3 ft / 1 m distance from other Ford wheels. I recommend further, like the far side of the garage. Even if confused, yes, they should automatically sync within the first tens of yards/meters of driving, with no other traffic around. Ford's units...
^ This, +1.
When driving on the street, it's not a good idea to run below 1/4 of a tank.
If on a course or track, many will start with a 1/2 tank, then top up on break.
Those with aftermarket pump setups or configurations might have other guidelines.
It's to help keep the pump protected, to...
I've seen two impediments to getting fuel out by siphoning.
As @Bikeman315 :thumbsup:points out, the difficulty of getting the right-sized hose into the tank. At the bottom of the neck, there's at least one "X" restrictor, like a cross; the small hose has to enter one of the four openings just...
To compliment the discussion, it'd be a good idea to confirm a filler funnel exists, for anyone's car. Odds are it's there. But the driver might not be familiar with it and why used.
The cap-less system relies on two flaps. A nozzle of the correct size and length has to be inserted in the...
Some additional thoughts on safety:
- Never buy a used charger or tender
- Only purchase from a known vendor or business
- Install and use the device per the instructions
A byproduct of the charging process on many batteries is hydrogen gas. If charging, I'd rather keep the unit in a well-ventilated place and away from any other sources of ignition (hot water heater or furnace).
If not charging, the unit could be stowed potentially anywhere. I'd prefer away from...
Be mindful of the tires and any markings on the sidewalls.
Many tires are directional and would not perform the same if facing the wrong direction.
I use the following tools to monitor the tires and alignment...
I'll explain one option, based on an apartment setup I had lived in previously.
At one location, I had an outside balcony and outlet.
Boat shops often sell plastic containers to hold batteries, with a cover. The objective is not to seal it off, but cover it from the elements. Additionally, it...
I'm on a Gen3, but yes, the pressures you're seeing are normal.
https://www.mustang7g.com/forums/threads/lets-see-your-gauge-details-what-is-normal.161804/
^ This was a thread started by @JAM486HP :thumbsup: . It provides a lot of insight as to what people are seeing across all their gauges...
Along with what others contribute this morning, I'm enclosing links of previous threads.
https://www.mustang7g.com/forums/threads/thoughts-on-paint-protection-wrap-ceramic-teflon.157283/...
Ya, I highly recommend deep reading and listening to what people (S650 Owners) have done, in-person if possible.
A lot of people mean well. Unfortunately, it seems about 75% end up with an exhaust note that just isn't right, often too loud. A second change or mod often brings about what they...
https://www.mustang6g.com/forums/threads/is-it-possible-to-add-active-exhaust-to-my-non-active-car.189193/
Some deeper insight, with an S550 as an example.
https://www.mustang7g.com/forums/threads/introduce-yourself-to-mustang7g.156050/
Welcome to the Forums. :fistbump:
So...can you clarify your objective to us? Are you going for a look? A sound?
https://www.mustang6g.com/forums/threads/how-does-the-active-exhaust-work.181432/
^ This thread...
As a follow-up, none of these systems use signatures. If you're in a garage full of Fords and try to reset or change your TPMS, you could end up confusing your own with another; I recently confirmed this with my truck, while sitting in traffic.
If resetting or checking, Ford recommends being...
1. There is a Tire Pressure Monitoring System (TPMS) sensor attached to the valve stem.
https://performanceparts.ford.com/part/M-1180-B
Check out the photo in the link above. The square, electronic bit, attached to the valve stem, is the sensor.
2. Inside the sensor is a circuit board, a...
Do you have the original window sticker?
https://www.mustang7g.com/forums/threads/window-sticker-decoder-translated.158104/
https://www.mustang7g.com/forums/threads/guide-for-newcomers-ordering-vehicles-at-the-dealer.157583/
If you do, the guides above breakdown several of the fields.
I'd...
https://www.autoevolution.com/pdf/news_attachements/ford-recalls-2024-mustang-over-rear-suspension-knuckles-that-may-fail-238432.pdf
Serial numbers and how to check are in the attached. See Page 10.
Giving this thread a bump.
Attached is a photo of a car whose knuckle failed.
This car had exited a touch-less car wash moments before. I suspect, speculate, the dramatic changes in temperature weakened an existing fracture point to failure. Maybe that broke it. ๐คทโโ๏ธ Maybe it was going to...